Introduction
General settings are described in this chapter.
You can find specific settings in the chapters
about those settings. The available settings depend
on the vehicle equipment.
Date and time
Introduction
Applies to: vehicles with software update
You can update your vehicle's software.
The functions depend on the country and vehicle
equipment:
Update through the online system update
Map
Displayed connected devices
Requirement: the vehicle must be stationary and
the ignition must be switched on.
Applies to: MMI: Select on the home screen:
SETTINGS > Connected devices.
Possible
Calibration Device - VAS721001-, Installing and Aligning
After performing service work on the vehicle, it may be
necessary to calibrate the peripheral camera system. In detail,
this is the case after:
Replacing one or more cameras
Peripheral Camera Control Module -J928- replacement
Flash the
Fig. 168 Engine compartment: connectors for a charger or
jump start cables
Observe the safety precautions > General
information, in Battery general information
.
Requirement: only use chargers with a maximum
charging current of 14.8 volts. The battery cables
remain connected.
The charging cabl
System settings
