Audi Q7 Owners & Service Manuals

Audi Q7: Fluids in the A/C system

Refrigerant in the A/C system

The sticker in the motor compartment provides information about the type and amount of refrigerant used in the vehicle's A/C system. The sticker is located in the front section of the motor compartment or at the front or back of the hood.

Warning: the A/C system must only be serviced by qualified technicians.

Refrigerant type

Lubricant type

Refer to the service information (only available for authorized Audi dealers or authorized Audi Service Facilities)

The A/C system must only be serviced by qualified technicians.

Flammable refrigerant

Make sure all components are disposed of correctly and never install components in the vehicle that have been removed from old vehicles or taken from recycling.

Lubricant in the A/C system

The sticker in the motor compartment provides information about the type and amount of refrigerant oil used in the vehicle's A/C system. For the refrigerant oil quantity, refer to the Technical Data.

WARNING

To ensure secure and safe operation, the A/C system must only be serviced by qualified technicians and certified technicians (SAE standard J2845).

Tips

  • Never repair the A/C system evaporator with components from old vehicles or from recycling.
  • New replacement evaporators for portable A/C systems must be certified and labeled as such, so that they comply with the SAE standard J2842 HFO-1234yf and R744.

    READ NEXT:

     Driving

     Starting the vehicle

    Description Fig. 90 Center console: starting the engine Requirement: the key must be in the vehicle. Starting the engine Press and hold the brake pedal. Press the [START ENGINE STOP] button. Th

     When driving

    Starting to drive, stopping, and parking Starting from a stop Press and hold the brake pedal. Start the engine. Select "D" or "R". Release the parking brake. Release the brake pedal. The vehicle

    SEE MORE:

     Battery Charger -VAS5095A-

      WARNING Risk of injury. Follow all warning messages and safety precautions. Refer to → Chapter "Warnings and Safety Precautions". In order to prevent damage to the Battery -A- or vehicle, observe the battery type information. Refer to → Chapter "Battery Types".   WAR

     Overview - Rear Brakes

    1 - Bleed Screw 10 Nm Before installing, thinly coat with Assembly Paste -G 052 150 A2-. 2 - Protective Cap 3 - Bolt 35 Nm Replace after removing When loosening and tightening, counterhold at the guide pin Self-locking 4 - Gasket Replace afte

    © 2019-2026 Copyright www.a-q7.com