Audi Q7 Owners & Service Manuals

Audi Q7: Emergency flashers

Fig. 37 Center console: emergency flashers
Fig. 37 Center console: emergency flashers

The emergency flashers help to make other drivers aware of your vehicle in dangerous situations.

  • Press the (1) button to switch the emergency flashers on or off.

When the emergency flashers are turned on, the and indicator lights will flash at the same time.

You can indicate a lane change or a turn when the emergency flashers are switched on by using the turn signal lever. The emergency flashers stop temporarily.

The emergency flashers also work when the ignition is turned off.

Tips

You should switch the emergency flashers on if:

  • you are the last car in a traffic jam so that all other vehicles approaching from behind can see your vehicle
  • your vehicle has broken down or you are having an emergency
  • your vehicle is being towed or if you are towing another vehicle

Messages

The following messages may appear depending on the vehicle equipment: If the , indicator light turns on, a bulb has failed. The displayed message indicates the cause and possible solutions. If one of the messages remains on, drive immediately to an authorized Audi dealer or authorized Audi Service Facility to have the malfunction repaired.

Audi adaptive light: malfunction! See owner's manual

Adaptive light is not working. The headlights still function. Drive immediately to an authorized Audi dealer or authorized Audi Service Facility to have the malfunction repaired.

Headlight range control: malfunction! See owner's manual

There is a malfunction in the headlight range control system, which may cause glare for other drivers. Drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.

High beam assistant: malfunction! See owner's manual

You can still switch the high beams on or off manually. Drive immediately to an authorized Audi dealer or authorized Audi Service Facility to have the malfunction repaired.

High beam assistant: currently unavailable.

Camera view limited due to environmental conditions

This message appears if the camera's visual field is blocked. The system will switch itself off. Try switching the systems on later.

Automatic headlights: malfunction! See owner's manual

The light/rain sensor is malfunctioning. In the AUTO light switch position, the low beams remain switched on at all times for safety reasons.

Drive immediately to an authorized Audi dealer or authorized Audi Service Facility to have the malfunction repaired.

    READ NEXT:

     Interior lighting

    Front interior lighting Fig. 38 Headliner: interior lighting Interior lighting buttons - Interior lighting on/off - Door contact switch on/off. The interior lighting is controlled automatically.

     Vision

    Adjusting exterior mirrors Fig. 41 Driver's door: knob for the exterior mirrors Turn the knob in the driver's door to the desired position: 0 - Deactivates all adjustment functions. - Selects the l

     Windshield wipers

    Switching the windshield wipers on Fig. 45 Lever: windshield wipers Fig. 46 Lever: rear window wiper Move the lever to the corresponding position: (0) Windshield wipers off (1) Rain sensor/inte

    SEE MORE:

     Floor Heat Shield, Removing and Installing

    Plenum Chamber Bulkhead Heat Shield, Removing and Installing Removing - Remove the plenum chamber bulkhead. Refer to → Chapter "Plenum Chamber Bulkhead, Removing and Installing". - Remove the nuts -arrows-. - Remove the heat shield -1-. Installing Install in reverse order of r

     Subframe, Securing

    Special tools and workshop equipment required Torque Wrench 1331 5-50Nm -VAG1331- Torque Wrench 1332 40-200Nm -VAG1332- Engine and Gearbox Jack -VAS6931- Gearbox Support -T40173- Locating Pins -T40327-, not shown Procedure   WARNING There is a risk of an accident due to an unsecured

    © 2019-2024 Copyright www.a-q7.com