Only install tires with the same manufacturer, construction
type and tread on all wheels.
Always replace rubber valve when replacing steel wheel or
rim.
Install tires with DOT identification facing
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Wheel Lock Set -T10101-
Wheel Lock Set -T10101A-
Wheel Lock Set -T40004-
Wheel Lock Set -T40073-
Wax Spray -
Caution
Refer to
→ Chapter "Safety Precautions, Run-Flat Tires".
- Release air from tires, unscrew the valve insert to do so.
Note
Be careful not to scratch off the glu
Introduction
Applies to: vehicles with navigation system
You can update the map data in the MMI with a
map update. The functions depend on the country
and vehicle equipment.
Map update through online map update
Import a map update from the USB connection
to your MMI
Online map update
Applies to
Fig. 168 Engine compartment: connectors for a charger or
jump start cables
Observe the safety precautions > General
information, in Battery general information
.
Requirement: only use chargers with a maximum
charging current of 14.8 volts. The battery cables
remain connected.
The charging cabl