Audi Q7: Chassis

 Overview - Lower Control Arm and Ball Joint

1 - Wheel Bearing Housing Side Bonded Rubber Bushing Replacing. Refer to → Chapter "Control Arm Ball Bearing, Replacing, Wheel Bearing Housing Side". 2 - Control Arm Removing and installing. Refer to → Chapter "Control Arm, Removing and Installing". 3 

 Selector Lever Handle, Removing and Installing

  Note Both the selector lever handle and the selector lever boot are removed. Special tools and workshop equipment required Trim Removal Wedge -3409- Torque Wrench 1410 -VAG1410- Removing Ignition switched off. - Remove the selector lever handle upper section -1- upward in direc