Audi Q7 Owners & Service Manuals

Audi Q7: Run-Flat Tires

  Caution

It is mandatory for run-flat tires to have a tire pressure monitoring system in the vehicle.

Installing/Conditions for Using Run-Flat Tires

  Caution

It is mandatory for run-flat tires to have a tire pressure monitoring system in the vehicle.

Because pressure loss in a run-flat tire is not always visible, these tires should only be used on vehicles equipped with a tire pressure monitoring system. This system warns the driver when the tire pressure falls below a certain value.

The following are permitted:

  • Direct measuring systems
  • Indirect measuring systems

Only mount run-flat tires on disc wheels with an extended double hump (extended hump - EH2).

Pay close attention to the installation instructions.

Do not install both run-flat tires and standard tires, even if the two tires on each axle will be the same.

A standard tire can only be installed in exception cases for a short time or a limited driving distance. The specific characteristics designed for driving with a flat tire will not be available. The driver must be informed of this.

READ NEXT:

 Tires with emergency running characteristics, PAX

  Caution It is mandatory for run-flat tires to have a tire pressure monitoring system in the vehicle. Work on tires with emergency running characteristics (PAX) must only be performed at ski

 Tires with Emergency Running Characteristics, SST (Self-Supporting Tire)

  Caution It is mandatory for run-flat tires to have a tire pressure monitoring system in the vehicle.   Note Only vehicles with a tire pressure monitoring system are equipped with SS

 Tires with Emergency Running Characteristics, Seal Inside-Technology

  Caution It is mandatory for run-flat tires to have a tire pressure monitoring system in the vehicle. Examining and replacing the seal inside tires should only be performed by trained person

SEE MORE:

 Plenum Chamber Bulkhead, Removing and Installing

Plenum Chamber Bulkhead, Removing and Installing Removing - Drain the coolant. Refer to → Engine Mechanical; Rep. Gr.19; Cooling System/Coolant; Coolant, Draining and Filling. - Remove the plenum chamber cover. Refer to → Chapter "Plenum Chamber Cover, Removing an

 Component Location Overview - Storage Compartment/Covers

Component Location Overview - Storage Compartment/Covers 1 - Sun Shade, Rear Window Overview. Refer to → Chapter "Overview - Sun Shade, Rear Window". 2 - Luggage Compartment Roll Cover Overview. Refer to → Chapter "Overview - Luggage Compartment Roll Cover".

© 2019-2026 Copyright www.a-q7.com