Audi Q7 Owners & Service Manuals

Audi Q7: Tire Requirement and Maintenance

Audi Q7 (4M) 2016-2026 Workshop Manual / Chassis / Wheel and Tire General Information / Tire Requirement and Maintenance

READ NEXT:

 Introduction

This revised information should supplement the knowledge and experience you already have. With this information, we want to help you make as clear and certain a statement as possible concerning tire

 Tread Depth, Measuring

  Note When measuring tread depth, take measurements in the main grooves. Do not measure on the TWI (tread wear indicator). Tread depth of a tire must be measured in the main grooves at th

 Rubber Valve

1 - Valve body 2 - Valve Insert 3 - Valve cap 1. The Valve Body The rubber valve for tubeless tires is designed to seal air-tight in the hole in the rim. The elastic ma

SEE MORE:

 Tire Pressure Monitoring System

Tire Pressure Monitoring with Pressure Sensor   WARNING If tire sealant was used, then the wheel electronics on that particular wheel must be replaced. The wheel electronics, that is, the system pressure sensor, forms a physical unit with the valve.   Note The lettering on the wheel e

 Fiber-Optic Cables, Repairing

  Caution Do not bend the fiber-optic cable too much. The bending radius must be no less than 25 mm. Fiber optic cables must not be routed over sharp edges. The fiber-optic cable must not be dirty or touched with bare fingers. Fiber optic cables may not be heated. It is not permitted to tw

© 2019-2026 Copyright www.a-q7.com