Audi Q7: Wheel and Tire Guide
Audi Q7 Type 4L
(Edition 11.2015)
This Is the Wheel and Tire Guide for the following Models:
→ Chapter
"Audi Q7 Type 4L, Model Year 2007"
→ Chapter "Audi Q7, Type 4L, MY 2008"
→ Chapter "Audi Q7,
Type 4L, MY 2009"
→ Chapter "Audi Q7, Type 4L, MY 2010"
→ Chapter "Audi Q7,
Type 4L, Model Year 2011 - 2015"
"Audi Q7"Type 4M"
→ Chapter "Audi Q7, Type 4M, MY 2015 through
2016"
Play Close Attention to the Corresponding Notes and Cautions
as Well as the Comments in the Document.
WARNING
4L type rims cannot be combined with 4M type rims.
- 4L type: 71.58 mm inner diameter, 130 mm hole
circle, 5 wheel bolts, tightening specification: 160 Nm
- 4M type: 66.5 mm inner diameter, 112 mm hole circle,
5 wheel bolts, tightening specification: 160 Nm
Note
Refer to
→ Chapter "Air Pressures"
WARNING
Q7 type 4L: The wheel size 19" and larger are only
allowed when a steering arm thrust ring is installed on
the vehicle.
Spare Tire

Audi Q7, Type 4M, MY 2015 through 2016

Note
Play close attention to the corresponding notes and cautions
as well as the comments in the document.
General Information
WARNING
4M type rims cannot be combined with 4L type rims.
- 4M type: 66.5 mm inner diameter, 112 mm hole circle,
5 wheel bolts, tightening specification: 160 Nm
- 4L type: 71.58 mm inner diameter, 130 mm hole
circle, 5 wheel bolts, tightening specification: 160 Nm
3.0L TFSI Engine, 245 kW
Audi Q7, Type 4M
Note
- These are the tire/wheel combinations that are technically
possible for the vehicle.
- Check if the desired rims or wheel sizes are valid for the
affected vehicle.

1) Only with brakes PR number 1ZA, 1ZK, LN, 1LP
XL = Extra Load, Reinforced
Revision History
DRUCK NUMBER: A005Q703521

READ NEXT:
Towing Guide
Note
This is a "guide" for Audi models and their towing weights.
The proper towing weight of the respective vehicle must
always adhere to the corresponding vehicle document (c
Legal Requirements
The manufacturer is granted general type approval for the
whole vehicle including all parts and for specific retrofitting
(general type approval according to 20 StVZO (Motor Vehi
SEE MORE:
Fig. 5 Upper display: adjusting the display
Switching the view
Press the VIEW button to switch between the
default view (1) and the enhanced view (2).
Adjusting the layout
Depending on the vehicle equipment, various layouts
may be available.
Applies to: MMI: Select on the home screen:
SETT
The luggage compartment lid can be released from the inside in an
emergency.
Fig. 30 Inner luggage compartment lid: access to the emergency release
Fold the backrest on the rear bench seat forward
Remove the mechanical key
Using the mechanical key, pry the cover
off
the luggage compartmen