Audi Q7: Charging the 12 volt vehicle battery
Fig. 168 Engine compartment: connectors for a charger or
jump start cables
Observe the safety precautions > General
information,
in Battery general information
.
Requirement: only use chargers with a maximum
charging current of 14.8 volts. The battery cables
remain connected.
The charging cable connections are located in the
motor compartment. The ground point (-) is always
located on the vehicle body.
- Switch off the ignition and all electrical equipment.
- Open the hood.
- Press the release lever on the positive terminal
and fold the cover upward > fig. 168.
- Clamp the terminal clamps on the charger correctly
onto the positive terminal (+) and the
ground point (-).
- Insert the power cable for the charger into the
socket and switch the charger on.
- At the end of the charging process, switch the
charger off and pull the power cable out of the
socket.
- Remove the charger terminal clamps.
- Close the cover on the positive terminal.
- Close the hood.
WARNING
Tips
Read all of the manufacturer's instructions
for the charger before charging the battery.
READ NEXT:
Fig. 169 Motor compartment: washer fluid reservoir cap
The windshield washer reservoir contains the
cleaning solution for the windshield/rear window*
and the headlight washer system fig. 169. The r
General information
Check your tires regularly for
damage, such as punctures,
cuts, cracks, and bulges. Remove
foreign objects from the tire
tread.
If driving over curbs or similar
obstacles,
SEE MORE:
Function overview
Applies to: vehicles with Audi pre sense
Within the limits of the system, the Audi pre
sense functions can initiate measures in certain
driving situations to protect the vehicle occupants
and other road users. Depending on the vehicle
equipment, various Audi pre sense systems
may b
Overview - Steering Column, Manual
1 - Bolt
20 Nm +90º
Replace after removing
Clean the threaded hole, for example, using a thread tap, before
installing the new bolt.
Install the bolt first by hand in the first threads. Check if the
steering intermediate shaft is seated correctly