Audi Q7 Owners & Service Manuals

Audi Q7: Pausing park assist plus

Applies to: vehicles with park assist plus

You can pause park assist plus at any time by releasing the button (1), fig. 137.

To resume the process of parking or exiting the parking space, press and hold the button again.

Canceling automatically

Park assist plus is canceled automatically among other things, if:

  • If you switch off the system
  • You take over steering or press the brake pedal,
  • If the time limit is exceeded
  • If an obstacle is detected
  • If the ESC intervenes

Resume control of the vehicle, end the process of parking or exiting the parking space manually, or:

You can resume the parking process in some situations.

Press and hold the brake pedal and press .

WARNING

Observe the safety precautions and note the limits of the assist systems, sensors, and cameras.

Messages

Applies to: vehicles with park assist plus

If the or indicator light turns on, the park assist is not available or was interrupted.

A message that indicates the cause and possible solution may appear with some displays. The weather conditions may be too poor or a sensor may be covered. Clean the area in front of the sensors and try to turn the system on again later.

If the malfunction remains, drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.

    READ NEXT:

     Remote controlled parking

    General information Applies to: vehicles with remote park assist plus Remote controlled parking is part of park assist plus. The process for parking or exiting a parking space can be controlled w

     Parking with the myAudi app

    Fig. 139 Upper display: remote controlled parking - preparing the vehicle Requirements The setup has been completed. You are logged into the vehicle with your myAudi user. Bluetooth is s

     Maneuver assist

    Description Applies to: vehicles with maneuver assist Fig. 140 Upper display: maneuver assist General information The maneuver assist supports the driver when maneuvering and parking by mon

    SEE MORE:

     Connector Couplings

    Connector Couplings, Disconnecting Connector Coupling Allocation   Note The connector couplings for fuel, vacuum and breather lines are color-coded. There is either a colored dot on the connector coupling, or the release button has the corresponding color. Color Coding   WARNING Th

     Rear Three-Point Seat Belt, Removing and Installing

    Outer Second Row Rear Three-Point Seat Belt, Removing and Installing Removing - Remove the rear belt anchor. Refer to → Chapter "Rear Outer Belt End Fitting, Removing and Installing". - Remove the C-pillar trim panel and guide out the seat belt webbing. Refer to → Chapter

    © 2019-2025 Copyright www.a-q7.com