Audi Q7 Owners & Service Manuals

Audi Q7: Selector Mechanism

Audi Q7 (4M) 2016-2026 Workshop Manual / Transmission / Controls, Housing / Selector Mechanism

READ NEXT:

 Overview - Selector Mechanism

1 - Selector Mechanism With the following integrated components: Selector Lever -E313- Selector Lever Position Sensor -G727- Transverse Selector Lever Lock Sensor -G868- Selector Le

 Selector Mechanism, Checking

  WARNING Risk of injury and accident by accidentally engaging a selector lever position with the engine running. Before working with the engine running, move the transmission into "P" and

 Selector Lever Handle, Removing and Installing

  Note Both the selector lever handle and the selector lever boot are removed. Special tools and workshop equipment required Trim Removal Wedge -3409- Torque Wrench 1410 -VAG1410- Removing

SEE MORE:

 Balancing

General Information Before beginning balancing, the following requirements must be fulfilled. Tire inflation pressure must be OK. The tire tread must not be worn down on one side and should be at least 4 mm deep. The tire must not have any flat spots. It is not possible to balance a flat spot

 Tower Brace, Removing and Installing

Tower Brace Additional Reinforcement, Removing and Installing, Q7 without High-Voltage System Special tools and workshop equipment required Pry Lever -80-200- Torque Wrench 1331 5-50Nm -VAG1331- Removing - Remove the plenum chamber cover. Refer to → Body Exterior; Rep. Gr.50;&

© 2019-2026 Copyright www.a-q7.com