When the ignition is switched on, you may be
able to use multiple power sources for external
devices, depending on the vehicle equipment.
12 volt sockets
You can connect electrical accessories to the
Applies to: vehicles with cup holders
Fig. 76 Front center console: cup holder
Fig. 77 Center armrest in the second row*: cup holder
Your vehicle has cup holders in the front
center console, in
General information
All pieces of luggage or objects must be securely
fastened in the luggage compartment. Note the
following to maintain good vehicle handling:
Distribute the load evenly in the lug
Removing
- Disconnect the door connector -2-
from the B-pillar. Refer to
→ Electrical Equipment; Rep. Gr.97; Connectors.
- Tape off the B-pillar in the door arrester area using
adhesive tape, so that the paint will not be damaged.
- Remove the bolt -1- for the
doo
Upper Transverse Link
1 - Wheel Bearing Housing
2 - Bolt
70 Nm +180º
Replace after removing
Must be tightened in the curb weight position. Refer to
→ Chapter "Wheel Bearing at Standard Vehicle Height, Lifting Vehicles
with Air Suspension".
3 - T
Power sources
