Audi Q7 Owners & Service Manuals

Audi Q7: Emissions control system

General information

WARNING

The temperature of the exhaust system is high, both when driving and after stopping the engine.

  • Never touch the exhaust tail pipes once they have become hot. This could result in burns.
  • Do not park your vehicle over flammable materials such as grass or leaves because the high temperature of the emissions system could start a fire.
  • Do not apply underbody protectant in the exhaust system area, because this increases the risk of fire.

Catalytic converter

Observe the safety precautions General information.

The vehicle may only be driven with unleaded gasoline, or the catalytic converter will be destroyed.

Never drive until the tank is completely empty.

The irregular supply of fuel that results from that can cause engine misfires. Uncombusted fuel could enter the exhaust system, which could cause overheating and damage to the catalytic converter.

Malfunction Indicator Lamp (MIL)

If the indicator light blinks or turns on, there is a malfunction that is causing poor emissions quality and that could damage the catalytic converter.

Drive slowly to an authorized Audi dealer or authorized Audi Service Facility to have the malfunction corrected.

The indicator light can also turn on if the fuel filler cap is not closed correctly.

    READ NEXT:

     Motor compartment

    General information Special care is required if you are working in the motor compartment For work in the motor compartment, such as checking and filling fluids, there is a risk of injury, scalding, ac

     Opening and closing the hood

    The hood is released from inside the vehicle. Fig. 162 Footwell: release level Fig. 163 Unlocked hood: lever Observe the safety precautions General information. Make sure the wiper arms are not ra

     Engine oil

    If the engine oil level too low If you need to add engine oil, use an oil that is listed on the sticker. The sticker is located at the front of the engine compartment fig. 164. When using the engine

    SEE MORE:

     Overview - Sun Shade

    Overview - Sun Shade, Side Window 1 - Bolt 3.3 Nm Quantity: 4 2 - Sun Shade Cover Removing and installing. Refer to → Chapter "Sun Shade, Removing and Installing, Side Window". 3 - Bolt 1.7 Nm Quantity: 2 4 - Sun Shade Mounting Eye Remov

     Diagnostic Mode 0A - Check Permanent DTC Memory

      Note The following is a generic explanation of the requirements, coverage, and operation of Mode 0A. Mode 0A may only be supported exclusively by OBD control modules in US vehicles. Mode 0A may not be supported in EOBD vehicles, meaning the control module may not send a response her

    © 2019-2025 Copyright www.a-q7.com