Final Drive Identification
Final Drive Identification, 0DB, 0D2
The 0DB Rear Final Drive Unit Is Assigned to the following
Transmissions:
7-Speed Dual Clutch Transmission 0CK
The 0D2 Rear Final Dr
Transmission/Engine Allocation
Codes, Transmission Allocation, Ratios, Audi A4
Production time period.
Allocation to engine
Allocation to the automatic transmission via the codes and
PR numbers
SEE MORE:
General Information
Before beginning balancing, the following requirements must
be fulfilled.
Tire inflation pressure must be OK.
The tire tread must not be worn down on one side and should
be at least 4 mm deep.
The tire must not have any flat spots.
It is not possible to balance a flat spot
Overview - Stabilizer Bar
1 - Stabilizer Bar
Removing and installing. Refer to
→ Chapter "Stabilizer Bar, Removing and Installing".
With rubber bushing
The bonded rubber bushing cannot be replaced separately
2 - Subframe
3 - Nut
Replace after removing
4
Identification
