Audi Q7 Owners & Service Manuals

Audi Q7: Sun Shade, Removing and Installing

Sun Shade, Removing and Installing, Side Window

Removing

- Remove the rear door trim panel. Refer to → Chapter "Rear Door Trim Panel, Removing and Installing".

- Remove the bolts -1 and 2-.

- Remove the sun shade from the door.

A68-10783

Installing

Install in reverse order of removal.

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Sun Shade, Side Window".

Sun Shade, Removing and Installing, Rear Window

Special tools and workshop equipment required

  • Trim Removal Wedge -3409-
  • Omega Clip Tool -T40280-

Removing

- Remove the rear lid lower trim panel. Refer to → Chapter "Rear Lid Lower Trim Panel, Removing and Installing".

- Unclip the cover -1- with the -3409- from the sun shade in direction of -arrows- and remove.

A70-11813

- Remove the bolts -2 and 3-.

- Remove the sun shade -1- from the rear lid lower trim panel -arrows-.

A70-11814

Installing

Install in reverse order of removal.

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Sun Shade, Rear Window".

Sun Shade Mounting Eye, Removing and Installing

Sun Shade Mounting Eye for Side Window, Removing

- Remove the screws -1- and remove the mounting eye -2- from the window frame.

A70-11676

Sun Shade Mounting Eye for Rear Window, Removing

- Unclip the cap with a screwdriver in direction of -arrow A- and remove the bolt behind it.

- Unhook and remove the rear window shade mounting eye -1- from the bracket in direction of -arrow B-.

A70-11738

Installing

Install in reverse order of removal and note the following:

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Sun Shade".

    READ NEXT:

     Roof Grab Handle, Removing and Installing

    Special tools and workshop equipment required Angled Screwdriver -VAS6543- Removing   Caution Unclip the expanding caps -2 and 3- but only up to their lock position (do not pull them out

     Luggage Compartment Roll Cover, Removing and Installing

    Luggage Compartment Roll Cover Handle, Removing and Installing Removing - Remove the luggage compartment roll cover. - Open the lid -1- and remove the bolts -2-. - Loosen the roll cove

     Overview - Center Console

    Overview - Center Console 1 - Center Console Support Removing and Installing. Refer to → Chapter "Center Console Support, Removing and Installing". 2 - Center Console

    SEE MORE:

     Connector Housings and Connectors, Repairing

    Connector Housings and Connectors, Repair Information   Note Observe general notes for repairs on the vehicle electrical system. Refer to → Chapter "Vehicle Electrical System, General Repair Information". Allocation of crimp contacts with correct fit to connector housing is perfo

     Wiring Harness Repair Set

    Wiring Harness Repair Set -VAS1978- The Wiring Harness Repair Set -VAS1978- makes optimal repair quality possible in the realm of vehicle electronics. Using the tools, repairs affecting harness connectors and for breaks in wiring can be performed. For this purpose, complete repair wires with ter

    © 2019-2025 Copyright www.a-q7.com