Audi Q7: Body

 Tie Rod, Removing and Installing

Special tools and workshop equipment required Torque Wrench 1332 40-200Nm -VAG1332- Torque Wrench Insert - Open Jaw -VAG1923- Removing   Note Follow the guidelines for clean working conditions. Refer to → Chapter "Guidelines for Clean Working Conditions". - Remove the boot. Re

 Repairing a Wire 0.35 mm 2 or Greater with Individual Crimp Connector

Procedure - Free up the wire to be repaired approximately 20 cm on both sides of the repair point.   Caution Risk of damaging the electrical wires. Expose wrapped wiring harnesses carefully. - If necessary, removing the wiring harness wrapping using a knife. - Cut out the dam