1 - Bolt
3 Nm
2 - Sunroof Motor -V1-
Removing and Installing. Refer to
→ Chapter "Sunroof Motor -V1-, Removing and Installing".
Perform the adaptation after install
To complete the procedure, a second technician is required to be at the
following position.
Removing
- Remove the headliner. Refer to
→ Body Interior; Rep. Gr.70; Roof Trim
Removing
- Remove the front glass panel. Refer to
→ Chapter "Glass Panel, Removing and Installing, Front".
- Remove the wind deflector. Refer to
→ Chapter "Wind Deflector, Re
Removing
- Disconnect the door connector -2-
from the B-pillar. Refer to
→ Electrical Equipment; Rep. Gr.97; Connectors.
- Tape off the B-pillar in the door arrester area using
adhesive tape, so that the paint will not be damaged.
- Remove the bolt -1- for the
doo
Description
Fig. 90 Center console: starting the engine
Requirement: the key must be in the vehicle.
Starting the engine
Press and hold the brake pedal.
Press the [START ENGINE STOP] button. The engine
will start.
Equipment that uses a lot of electricity is switched
off temporarily when you