The type label for refrigerant and filling capacities is
located on the hood.
1 - Refrigerant oil identification (here PAG oil) and additional
information. Refer to
→Fluid Capacity Tab
Front Seat Heating
Note
Depending on vehicle equipment, there are different versions
of the A/C system for the Audi Q7. Make sure to use the correct
version and pay attention to the allocati
Front Seat Ventilation
Components that are involved in the activation of the front
seat ventilation
The Front A/C Display Control Head -E87- sends the request
to switch on the seat ventilation (and
1 - Transmission
2 - Hose Clamp
Replacing
3 - Driveshaft
Removing and installing. Refer to
→ Chapter "Driveshaft, Removing and Installing".
Removing and installing on the rear final drive. Refer to
→ Chapter "Drive Shaft, Removing from Rear Final D
Fresh Air Door Motor -V438-, Removing and Installing
Note
Therefore, perform the basic setting for the A/C system
after installation of the adjustment motor. Refer to Vehicle
Diagnostic Tester in the "Guided Fault Finding" function.
Using the "output diagnostic test mode" and "basic set