The type label for refrigerant and filling capacities is
located on the hood.
1 - Refrigerant oil identification (here PAG oil) and additional
information. Refer to
→Fluid Capacity Tab
Mode 07 makes it possible to check emissions-related faults
which appeared during the current or last driving cycle (pending
DTCs).
A pending DTC is saved the first time a fault is detected
(output via Mode 07).
- If the fault is detected again by the end of the following
driving cycle, a c
Removing
- Remove the rear lid seal from the body flange.
Installing
Install in reverse order of removal and note the following:
- Install the rear lid seal on the body flange in the
sequence: -1, 2 and 3-.
- Align the mark -A- on the rear
lid seal to the center roof frame seal hole