1 - Center Instrument Panel Vent Illumination Bulb -L68- Right
Cannot be replaced separately if faulty.
Replacing. Refer to
→ Body Interior; Rep. Gr.70; Instrument Pan
Component Location Overview - Front Door Ambient Lighting
1 - Left Front Door Contour Illumination Lamp
Removing and installing. Refer to
→ Chapter "Left Front Door Contour Illum
Removing
- Turn the light switch to position "0".
- Press the tab -3- in using a
flat-head screwdriver and pry out the glove compartment lamp
-2-.
- Disconnect the connector -1-.
Inst
Fresh Air Door Motor -V438-, Removing and Installing
Note
Therefore, perform the basic setting for the A/C system
after installation of the adjustment motor. Refer to Vehicle
Diagnostic Tester in the "Guided Fault Finding" function.
Using the "output diagnostic test mode" and "basic set
Overview - Drive Axle
1 - Cover
Carefully drive off using a drift
Replace if damaged
Adhesive surface must be free of oil and grease
Coat the sealing surface with Sealant -D 454 300 A2- before installing on
CV joint.
2 - Circlip
Replace after removing
Insert in shaft